AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Vinyl record storage holder11/21/2023 ![]() ![]() Once you have the basic rectangles cut, the rest is fast and easy. A decent handsaw will cut out all the parts too - with a healthy dollop of elbow grease, of course. Most independent lumber stores will be more than willing to make cuts for a small charge. Once that’s done, you can do the rest of the project with simpler tools. Image used with permission by copyright holderĭon’t feel like jigsawing everything yourself? An alternative is to take the drawing below to your local hardwood retailer and ask if they will crosscut your pieces to rough length and “rip” them to the exact widths you need. The beauty of this project is that you can make all the same cuts with a jigsaw (though you’ll likely end up with rougher edges that will need more sanding). We began by chopping our pieces to rough length using our trusty miter saw, and then cut them to width on a table saw - but don’t worry if you don’t have access to a table saw. If you’re going this same route and using one board for the whole project, you’ll need a slab that’s at least 60 inches in length. We went with the latter option and started with a single hardwood board, roughly 1 inch thick and 10 inches wide, though a slightly thinner or narrower board would work too. You can embark on this project in one of two ways: either start with multiple smaller boards of the same thickness, or use one large board and chop it up to create the pieces you need. Step-by-Step Build Process Step 1: Get some wood and cut it to create your four pieces Miter Saw (capable of cutting 10-inch boards).Hardwood slab (roughly 1 inch thick, 10 inches wide).Tools and Materials Image used with permission by copyright holder
0 Comments
Read More
Leave a Reply. |